In this video I’ll show you several mistakes I made while finishing a bar top. I’m hopeful that you can learn from my mistakes, so you...

In this video I’m building a custom top for a bar I built complete with a 6” wide bar rail that you just want to lean on.

In this video I’m building a small stand for my laser level. I’m using items that I had on hand in the shop, and while I’d like the...

In this video I’m building an end grain cutting board in maple and walnut

In this video I’m building a new push stick with an adjustable rear block, to be used mostly on the table saw.

In this video we'll talk about what you might want to know before buying your first, or next router. Motor sizes, speeds, features and...

In this video I’ll show you that repairing / rebuilding a pneumatic nail gun is a fairly simple and quick process. No need to send your...

Imported plywood isn't known for it's ability to give you clean cuts, especially when cutting across the grain. Thin veneers, internal...

In this video I’m going over four more add ons to a drill press to make using it more convenient; making the new table more secure,...

In this video I’m building a new table for my bench top drill press. The original table is small and a challenge to use, and my old...

I just made one more update to my Shop Vac / cyclone separator cart, and there's a quick video to show you how it came together.

This video shows you a couple of techniques to run short or narrow stock through your planer, and get good results, safely.

In this video I’m building a new stand for my bench top drill press If there is interest in plans for this stand, please DM me and I’ll...

In this video I’m building a mobile stand to house my shop vac and dust deputy dust separator. This should save me a bundle on replacing...

In this video we’ll build a quick and easy knife block that will keep your knives safe and in easy reach.

In this video I’m going to show you how build a mantle and install it with no visible bracing.

In this video I’m going to show you how to apply a water-based finish over an oil based stain. Normally, without some kind of barrier...

In this video I’m building a new case for my 8” Freud stack dado set.

In this video we’re going on a shop tour of my small and sometimes messy shop.

In this video I’m building a French cleat shelf to store my new tapered bits. They will be stored together with all their accessories...